Find Your Part:
Search
OR


Return to Parts List

Category : A- Small Block "LA" : Camshaft : Hydraulic Roller

HUG SER3034ALN-10

SB HYD RLR CAM 230/234 -110šLSA NEW CORE

LONG SNOUT & DRILLED FOR OILING WITH .353"/.357" LOBE LIFT

$369.00


Hughes "SteamRoller" Cam



This is a long snout cam. It works fine in the  93-03 Magnum engine but you will need to use our HUG7011 Cam bolt & washer and the HUG7542 cam key (see below in Related Parts).
 
Hydraulic roller small block camshaft.

Basic guidelines  (These are not absolutes, just guidelines to help you get close on a cam choice)
Use: Serious Street/Strip, works well with fully ported or aftermarket heads and high flow throttle body/carb , upgraded injectors a/r
Idle: Noticeable
Vacuum: low to mid
Converter: 3200+ stall
Rear gear:  3.55 +
Benefits:490+HP potentiel at flywheel
Requires a computer upgrade (like a tuner)

     




Related Parts:


Lifters
: Magnum Blocks Standard performance use HUG 5006  High performance use HUG 5007
             LA Blocks use HUG 5321

Valve Springs: For 1.5 or 1.6 ratio rockers use HUG 1129 Note: Spring base must be machined flat on OEM heads. Both springs must set on the same surface.

Valve Locks:    For 5/16" stem use  HUG 1307B
                          For 11/32" stem use HUG 1302   For 3/8" stem use HUG 1304 for single-groove, HUG 1346 for multi-groove.

Retainers:  For 5/16" stem use HUG 1278
                    For 11/32" stem use HUG 1202    For 3/8" stem use  HUG 1252

Rocker Arm Kits: On Magnum iron heads use HUG 1550 or HUG 1555
                             
On Magnum Edelbrock Heads use HUG 1560 or HUG 1555A
                              On standard LA style heads use 1.5 ratio HUG 15023  For 1.6 ratio use HUG 15063

Cam Key: For LA or Magnum engines use    HUG 7542 

Cam bolt & washer: HUG 7011

Timing Chain & Gear Set: 3 key way use HUG 6440 or for a 7 keyway use HUG 6442

Home | Phone: 309-745-9558 | Email: information@hughesengines.com